![]() ![]() I figured it may be aruba compat with passive DAC tranceiever. Last clearing of counters: 0d 00:00:00 agoġ08 unicast, 24257 multicast, 2258 broadcast Link status last changed: 0d 00:00:00 ago Hardware is Gigabit Ethernet, Interface is thor-vmnic0, Address is 00:0b:86:a8:e1:f2Ĭonfigured: duplex (Full), Speed (1 Gbps), FC (Off), Autoneg (On) GE0/1/0 is administratively Up, Link is Down, Line protocol is Down (sw0) (config) # show interface gigabitethernet 0/1/0 Interface-profile switching-profile access_101 Interface-profile enet-link-profile 10Gb_Full Interface-profile poe-profile poe-factory-initial Lldp med-tlv-select power-management Enabled Lldp med-tlv-select network-policy Enabled Lldp tlv-select aggregation-status Enabled Lldp tlv-select management-address Enabled Lldp tlv-select system-capabilities Enabled Lldp tlv-select system-description Enabled Interface-profile lldp-profile lldp-factory-initial Interface-profile pvst-port-profile default Interface-config gigabitethernet "0/1/0" detail (sw0) (config) #show running-config interface gigabitethernet 0/1/0 Interface-profile enet-link-profile "10Gb_Full" Interface-profile switching-profile "esxi_host" Interface-profile switching-profile "default" Interface-profile switching-profile "access_101" So access mode VLAN 101 is all that is needed. I was ready to plug hosts in and hit the ground running.ģ Meter DAC Cable to each "second port" on ESXi 7 host. Once I had vlans created and IPs bound I created profile. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |